Neutrik NK-NAC3FXXA-W-S powerCON Locking Cable Connector | 3-Pole Power-In | Blue Insert V-0

Locking Power Connector for Equipment

The Neutrik NK-NAC3FXXA-W-S is a powerCON cable connector for AC power-in. The listing describes it as a lockable, three-conductor equipment connector with contacts for line, neutral and a pre-mating ground. It is used where a rugged locking connection must replace a standard appliance coupler in lighting, audio and broadcast power distribution. Confirm the required length and connector type when you request a quote.

Locking and Ground Contact

The powerCON locks mechanically once mated, so the supply cannot pull out during a show or a shoot. The pre-mating ground contact connects earth before the live pins make contact, which improves safety when the connector is plugged in under load. Check the specification against your project brief before placing an order. Confirm the required length and connector type when you request a quote.

Termination and Insert

This is a cable connector with screw terminals, which are used to wire the conductors directly. The insert is blue and rated V-0 for flame performance. Use wire sizes and strain relief rated for the connector, and follow the local wiring rules when the supply is mains voltage. Share the route and quantity with your enquiry so the quote matches the job.

Compatibility and Safety

Powered equipment must match the powerCON rating, and the mating receptacle must be from the same family to guarantee the lock and contact design. Only qualified persons should terminate mains connectors, and each connection should be checked before the power is applied. Confirm the required length and connector type when you request a quote. Keep the route plan and connector list ready so the quote reflects the real job.

Choosing the powerCON Connector

Choose the NK-NAC3FXXA-W-S for locking AC power leads on stage, studio and outside broadcast equipment. For data or signal connections, the other connector families in this range apply. Neutrik products are quoted per connector and quantity. Check the specification against your project brief before placing an order. Confirm the required length and connector type when you request a quote.